WiseSage

The tang at one end detaches effortlessly. Extremely fragile.

During my previous attempt to replace a bulb in the sun visor lamp, I damaged it when attempting to extract it from the headlining. It cost me £40 to replace both items. I possess one with a burnt-out bulb, necessitating its replacement. What is the optimal technique for removing a lamp or replacing a bulb without causing damage to the light?

🤨

Left side of the engine, orientated towards the front as observed from the front.

Intake shutoff mechanism?

Greetings everyone, I seek clarification regarding my 2011 Mercedes E350.Upon acceleration, I experience hesitation when fully depressing the accelerator. The vehicle has been examined by a Mercedes specialist, who installed a new genuine EGR valve and performed a DPF cleaning.I received a message when placed on a dynamometer, which I will upload. I replaced a pressure sensor today, as there are no fault codes recorded. However, there is a reluctance in acceleration. I am not an expert with these engines, but might a defective boost pressure, a malfunctioning glow plug, or deteriorating coil leads be responsible for this issue?I am perplexed by this situation.Any guidance would be greatly appreciated.

I also attempted the one with the brake, but to no avail. Truly perplexed!

Thank you for your appreciation. I have attempted 5 or 6 times, meticulously adhering to the directions, but to no avail. The following message appears, and when I turn off the ignition, the brake is immediately reapplied.

Thank you for your reply! I attempted that earlier today, or at least to the best of my understanding. However, I consistently observe that the instructions appear to be designed for automatic transmissions, whereas mine is a manual. Do you believe that would significantly alter the situation? I will attempt it once more nonetheless.

Hello, I am experiencing significant difficulties with the procedures and videos I have encountered for activating the electric parking brake into service mode to facilitate the replacement of the discs and pads. I have attempted the solutions suggested here and in various YouTube videos, nevertheless I have not achieved any success. I have attempted the procedure of holding the button and accelerator while turning the system off and on; nevertheless, I consistently receive an EPB error after approximately 30 seconds. Furthermore, as soon as I cease operation and switch it off, the brake engages automatically. Has anyone achieved success with this, or does anyone with the same model own a viable answer, or is it really an online myth? I appreciate any assistance you can provide in advance.

😍

https://www.thewheelshop.co.uk/

Uncertain of Kia's pricing, however space saving kits are available for purchase from other retailers.

I have never seen a Kia equipped with a spare wheel, jack, and spanners for years. Unless Kia offers an accessory package at an additional cos

Is the list not printed on the lids of the fuse boxes?

🥰

Thank you, drummer. You are exceptional.

Greetings, everyone. Yesterday, I visited the dealership for an airbag recall. They do a visual inspection of the vehicle, assessing components such as tires and brakes. The front driver's side spring was discovered to be fractured. I also perceive it when I fracture it; there is an audible click that can be heard inside the cabin as well. I am considering replacing both front springs and the dust cover for the shock absorber. Should I replace the shock absorber in this instance? Must I replace both axles? I have observed that many vehicles exhibit a higher front and lower rear stance after the replacement of front shock absorbers. What is the most effective and rational approach to do this? 2012 BMW F10 530i (N53 engine)

Did you purchase the vehicle from a Mercedes dealership? If that is the case, they should resolve this for you free of charge. The process was conducted by email, eliminating the need for me to go. Alternatively, I would promptly visit your closest dealership with identification and selling data, since the prior owner may presently use the app to monitor, find, and unlock your vehicle. The Mercedes Me support crew is really competent; but, I anticipate that you will be required to provide physical documentation (e.g., at a dealership) to register the vehicle in your name.

morning everyone, I hope you'll have a nice ride

Indeed, I have perused some information on walnut blasting this evening and have encountered it throughout my travels. I will locate a vacuum source for the throttle body and introduce it accordingly. I have previously worked on many automobiles with my wife (now my ex-wife) while using the accelerator. I suppose I must seek an other somebody to do it. Is it the reason you have children?

I would want to do a thorough cleaning, replace the spark plugs, change the oil and filter, conduct regular maintenance, and provide a detailed cleaning.

Hello everyone, I have not been active here for a while. I am gradually making modifications to the W203. Following the replacement of the headlight lenses and a thorough wash, I will provide a picture or video if possible. I have a dilemma and would appreciate any advice. I own Nulon upper engine cleaner, which is sprayed into the manifold via a vacuum line to dislodge carbon deposits from the upper engine, allowing them to depart via the exhaust. I want to ascertain the most optimal and straightforward hoover line to utilise. I have typically located an intake immediately before the throttle body in prior vehicles. I do not intend to spray via the supercharger; nonetheless, would this have any implications or create any problems? I have used this branded cleaner on many vehicles and it has produced satisfactory results. Subsequently, do an oil change, as it is due and recommended. Thank you for any contributions.

Enjoying local beer while on vacation in Vietnam! I have successfully responded to my previous post. Apologies!

Completed the procedure on a C300d. They just required software modifications, not an EGR replacement. Did not impact anything. I said that they did not do any emissions software upgrade.