All Activity
- Past hour
-
I'm sorry, but I find your work style concerning. If you let the cylinders run dry, you're inviting trouble because the seals require constant moisture. On a damaged bike, the brake fluid will drain quickly. When bleeding the ABS unit, a scan tool is completely unnecessary. No need at all.
-
To fix some damage, I had to cut the front brake line, but I couldn't find a way to prevent fluid from leaking out of the cut. It appeared like the tank was totally empty when I added fluid before the manual bleed. A diagnostic tool that claims to be Mercedes-specific doesn't appear to function, and it's a little frustrating. It was supposed to be a quick task.
-
It is not necessary to bleed the ABS unit unless the fluid level in the master cylinder drops too low, allowing air to enter the system.
-
Salutations everyone, In search of some guidance. I would like to use the scan tool to bleed the abdominal system. After manually bleeding all of the brakes, I was told to activate the ABS pump and then bleed them again. There are two options that appear when I go to the menu that should list abs bleeding on my Launch Creader Elite diagnostic tool: ESP(R) (Electronic Stability Program) and electronic parking brake. After going into the ESP(R), the high pressure and return flow pump A7/3m1 is listed. I haven't tried activating it yet, but clicking on it does give me the option to do so for three seconds. In the videos when scanners are used, the user is walked through the process step by step. For example, the scan tool would tell them to press the brake pedal, open the bleed screw, let the ABS pump run for 10 seconds, and then close the bleeder. In my opinion, this is not the correct menu to use for bleeding, even if A7/3m1 appears to be related to abdominals. Which is why I decided to test out my Icarsoft v3 Merc scanner. 'Vehicle not supported'? After identifying the VIN and choosing ABS bleed from the menu, it stops working. Only a few months ago was the firmware changed, and now I'm completely bereft. My only Windows laptop is a corporate one, and they have restricted software downloads, so I won't be able to upgrade it until next week. Version 34.10 seems to be the one it's using. Have you any recommendations? This 2019 S205 is a C43. The car is now off the road for repairs, therefore I can't drive it in a wet parking lot or slam on the brakes because it is SORN and uninsured. I would prefer not to purchase another scan tool if that is possible as well. Much obliged
- Last week
-
Hello there, I'm grateful. Based on my cursory examination, it appears... One possible cause of water gathering under the passenger seat is a broken or leaking air conditioning line. This is the standard first diagnostic for this common problem, and I don't know how to fix it. It's like when I go to the mechanic and ask for brake pads without checking, and he says I also need new discs, which doubles the cost. 2) The second issue is a leaking windscreen seal, which can be simply fixed according to a YouTube video that shows how to use fairy liquid and a watering can to locate the leak.Instead of going to a mechanic and having them change it—which would be expensive and risky—I can do this and find out how to fill it. thirdly, seeping out of the lamppost. I'm crossing my fingers that it's this because I can easily fill up my boot with water. My section necessitates additional research. Hopefully, I will be able to determine the source of the problem by testing these things over the next few days. In the meanwhile, I am crossing my fingers that the upcoming week or so doesn't see an excessive amount of rainfall. I will also make sure to check the fuses; I really hope a new system isn't necessary. For some reason, I'm transported back to the 1980s while I'm driving right now. There is complete silence, no on-demand heating, and nowhere to charge my phone. The Sat Nav was useless anyhow, so I don't really miss it. I am not a happy Nissa Noter right now. Brenda must get herself together or else. This is an extremely musty Nissan Note E11 diesel driver's way of saying thanks.
-
I am far from being the most technically savvy person on this site.hence, I am clueless, but I would wager that you might be correct. The water leak is at the center of it all. I read a wide variety of topics when I initially arrived on this site. I thought there was a story concerning a passenger side leak? I believe it was the windscreen rubber, but I'll have to check into it and get back to you. I will try to locate it for you.
-
It all started with the screen and radio acting up, and eventually they just stopped working altogether. Additionally, the heater doesn't always work. After some time has passed with the engine running, it will turn on. I can't figure out where the car's serious leak is coming from; water collects primarily beneath the passenger seat. The electrical issues have me wondering if the mysterious leak is to blame. Any guidance would be greatly appreciated. Thank you ahead of time.
-
Your responses are greatly appreciated. I will investigate, but I haven't seen any differences at 75 mph. Going from sixth to seventh gear at forty miles per hour in comfort mode is par for the course. Have learned that the vehicle has received three upgrades over airwaves, which are as follows: November 26th, 2018: Communication module optimisation Enhanced Mercedes-Me module 9.11.23 Update for the Mercedes-Me module 3.6.21 Missing from all previous updates
-
Hello there, I have been experiencing issues with the automatic gearbox in my C class, which has logged 38,500 kilometres. Unless you utilise the paddles on the steering wheel, the automatic transmission will not change up from sixth gear to seventh gear and beyond. As expected, the gearbox shifts down, and up and down movement of the paddle shifters produces the desired effect. After driving on the self-learning cycle, the issue of not being able to shift into seventh speed at around 40mph reappears, even after resetting the automatic gearbox. I was informed by a Mercedes specialist that this model does not require a fluid replacement until 75,000 miles, however the automatic gearbox has not been serviced or changed since it was new. I had similar issue last year, but it went away in the late summer after a particularly warm spell. Now it's back. A scanner from the local garage, an Autel Maxisys 908s, detected four suspicious wheel speed signals—one for each wheel. Based on my little exploration of the web, I have discovered multiple instances of W205 auto gearboxes failing to engage in 2019 models. Does anybody have any ideas as to whether the issue is with the sensors or the software, and how much it will probably cost to fix it? Would appreciate any suggestions for an independent MB specialist (within a reasonable distance from Northwich, Cheshire) with an appropriate Star system who can diagnose the problem and fix it the first time around; I'm thinking of taking my car in for diagnostics. Even when the engine temperature is normal, the electric cooling fan continues to run after shutting off the engine, which is another intermittent defect. This seems to begin occurring after driving through numerous puddles. It seems to be a winter issue; I experienced the same thing last year, but it went away in the summer. Maybe Mercedees are starting to hate our rainy season. Though my two issues pale in comparison to the ones that Mr. Starmer is presently facing, I would really appreciate any feedback you could provide.
-
Get yourself into a comfortable driving position by adjusting the seat. Without massive "A" pillars obstructing my perspective, I require unobstructed visibility all the way around. Avoid putting undue strain on your finances by sticking to your budget. It has never been a concern of mine to stay abreast of the Joneses. I had fantasies about owning a Porsche a few years ago—and I could totally afford one—but I quickly realised that the "Running cost" would put it out of my price range.I ended up purchasing a Puma instead :(.