ML350_Colin Posted April 17 Share Posted April 17 Greetings, I am seeking information on the wiring of a Viofo Dashcam. I do not want to install a hardwire kit at this moment. Ideally, I would for it to be powered by the cigarette lighter; but, I am uncertain how to route it to the centre console. Could you please provide suggestions? Quote Link to comment Share on other sites More sharing options...
guyskin Posted April 17 Share Posted April 17 Connect it to the 12v socket, allowing sufficient slack at the plug end, then navigate it through the spaces between interior panels and under the dashboard (utilising clips or tape) until you arrive at the door. Proceed similarly down the side of the dashboard, then insert it beneath the A-pillar trim until you reach the upper edge of the windscreen. Subsequently, insert it under the roof liner to ensure the plug is correctly positioned. If surplus cable exists, coil it and store it along the path, such as under the dashboard or behind the kick panel in the driver's footwell. Quote Link to comment Share on other sites More sharing options...
ML350_Colin Posted April 17 Author Share Posted April 17 The issue is that the centre console lid cannot shut while the 12v plug is in use. Quote Link to comment Share on other sites More sharing options...
ML350_Colin Posted April 17 Author Share Posted April 17 The issue is that the centre console lid cannot shut while the 12v plug is in use. Quote Link to comment Share on other sites More sharing options...
guyskin Posted April 17 Share Posted April 17 Is it possible to use the 12v socket located in the rear? Alternatively, is a cable with an OBDII connector compatible with this model? Quote Link to comment Share on other sites More sharing options...
Auto Car Forum For Everybody
Auto Car Forum For Everybody
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.