All Activity
- Past hour
-
Many thanks to all of you. It is currently charging.
-
-
Another option is to use a 5-10w solar panel connected to the OBD port, which is always live, especially if the vehicle is kept outside and not near an electrical outlet.
-
Car Battery Chargers
-
A trickle charger is an essential tool for maintaining a battery's health when the vehicle is not in use. Every single one of the cars in any YouTuber's collection has a Ctek charger attached to it.
-
Requires charging, as mentioned earlier. The power required to simply stand a car is small, but it is still there. I'm still going strong after four months.
- Today
-
Because of its four-month history with the vehicle, this battery is obviously not brand new. Should be given a good run or charged.
-
After only a few starts, it's safe to assume the battery is dead. Starting drains a significant amount of juice, so simply turning it on and running won't replenish the charge. Once the battery is fully charged, it's a good idea to perform a parasitic drain test. Make sure to charge it thoroughly.
-
Amazon.co.uk : BimmerCode
-
Bosch BMW Ignition Coil OEM 04470/94937 (6pcs) : Amazon.co.uk: Automotive
-
Since then, it has only been started a couple of times; it has not been driven. The next time I want to use it, I'll have to reset the time on the clock, fix the yellow low battery light, and figure out how to unlock the boot without damaging the car. 80Ah 800 CCA was the initial battery specification. A Bosch 95Ah 800 CCA was used as a replacement. It was probably registered and coded with Bimmercode. For the past eight years, I've driven this vehicle without incident. Has the car's brand-new battery really died after four months of inactivity? Will I have to buy it all over again?
- Last week
-
Problems with BMW 118d N47N EGR Ventilation
VWDaveBMW replied to Matt865's topic in General Discussions
https://www.amazon.co.uk/s/?search-alias=aps&field-keywords=BMW+ISTA+diagnostic+software -
Problems with BMW 118d N47N EGR Ventilation
VWDaveBMW replied to Matt865's topic in General Discussions
My standard procedure is to use long-nose pliers to slide up the small white locking tab, then squeeze it to remove the plug. I believe that higher-spec foxwell, autel, launch, isa, etc., will be able to handle it, but the 301 won't. -
Problems with BMW 118d N47N EGR Ventilation
Matt865 replied to Matt865's topic in General Discussions
I was afraid it would be necessary to replace it by now, so I appreciate your help. Excuse my seemingly elementary question: is there a special technique for disconnecting the power cord? When I was cleaning the egr valve, I left it connected because I was afraid I would break it. Would it be better to use an app like Ista to reset the adaptations on my inexpensive scanning tool, the Fowell nt301? Many thanks -
Problems with BMW 118d N47N EGR Ventilation
VWDaveBMW replied to Matt865's topic in General Discussions
My apologies; I mistook it for having been replaced. If cleaning does not resolve the issue, the fault codes suggest a problem with the position sensing. Using a real Wahler valve is the way to go. In order for the ECU to learn the new valve positions, you must reset the adaptation with diagnostic equipment when you replace it. -
Problems with BMW 118d N47N EGR Ventilation
Matt865 replied to Matt865's topic in General Discussions
🙃 -
Problems with BMW 118d N47N EGR Ventilation
Matt865 replied to Matt865's topic in General Discussions
What exactly do you mean when you say "reset adaptation"? Instead of installing a new one, I simply cleaned the old one. -
Problems with BMW 118d N47N EGR Ventilation
VWDaveBMW replied to Matt865's topic in General Discussions
What brand of EGR did you install, and did you reset the adaptation? -
Problems with BMW 118d N47N EGR Ventilation
Matt865 replied to Matt865's topic in General Discussions
https://www.amazon.com/s?ascsubtag=v1-a484af-606291-72ad3856a6-k&k=BMW+EGR+valve -
Good day, I'm experiencing problems with the EGR valve. Here are the codes I'm seeing: The range and performance of the P046C EGR sensor 'A' circuit 'A' control for P042F EGR is stuck closed. The codes persist despite my two attempts to clean the egr valve. Can you suggest anything I should do after this? Many thanks
-
The rear camera is so bad that it's practically useless after a rainy trip unless you take it outside and wipe it down. The door mirrors, however, appear to have avoided the majority of the spray, so there is that.
-
Thank you! I was hoping they provided some protection, but I did notice that they were small. The EV2 will end up with a dirty rear end just like the EV3, which is a shame, but I suppose the spray can't be stopped from reaching that level.
-
In fact, when it rains, the EV2's upright back end becomes filthy. I had KIA mudflaps installed as part of the purchase, and I must say, they're not very practical at all! In addition to falling approximately 30 mm short of the bodywork, they barely cover half the width of the tires. In my opinion, they are grossly inadequate, so I wouldn't recommend them for the EV2 until aftermarket larger mudflaps become available.
-
I was wondering if the EV2 would experience the same issue as the EV3 did with the back end getting really dirty. My guess is yes. If that's the case, I'm curious if installing mud flaps will help.